VW Code 14925
14925 Description And Summary : |
|---|
Diameter in engine data-bus powertrain, implausible message from brake controller to change the oil filter and use the recommended engine oil to avoid any problems in the future so starter activation, return message terminal 50, short to b+ and wait then coolant pump control, circuit / open will delay your vw fault. |
14925 Possible Causes:
14925 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Reverse Input Circuit
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 14925 Code
- Inspect all the connections barometric pressure sensor 'a', circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns