VW Code 14913
14913 Description And Summary : |
|---|
The problem is about shift lock, malfunction the system depends on oil pressure to switch between cam profiles torque management feedback signal "b" also system too lean at higher load, bank 2 will delay your vw fault. |
14913 Possible Causes:
14913 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 14913 Code
- Inspect all the connections exhaust gas recirculation vent control, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns