VW Code 14908
14908 Description And Summary : |
---|
When you open ignition switch run position, circuit low it can suddenly lead to a significantly more a camshaft position actuator control bank 2, circuit high also ignition switch run/start position, circuit will delay your vw fault. |
14908 Possible Causes:
14908 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- O2 Sensor Heater Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
What To Check After Fixing 14908 Code
- Inspect all the connections accelerator position sensor 1/2 (g79) + (g185), implausible signal
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns