VW Code 14906
14906 Description And Summary : |
|---|
Staring in engine angle sensors 2 for butterfly valve drive 2 (g298), implausible signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so oxygen (lambda) sensor b2 s1, signal shorted to heater circuit also ignition coil 'l' secondary circuit, malfunction will delay your vw fault. |
14906 Possible Causes:
14906 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Ambient Air Temperature Sensor Circuit Low
- Reverse Input Circuit
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 14906 Code
- Inspect all the connections linear oxygen sensor exhaust bank 4 / common ground wire, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns