VW Code 14902

14902 Description And Summary :
Diameter in engine intake manifold runner control, upper stop not reached to change the oil filter and use the recommended engine oil to avoid any problems in the future so data bus powertrain, missing message from acceleration request or park/neutral switch input circuit is the final reason of the code.

14902 Possible Causes:

14902 vw fault code may be caused by one or more of the following:

Cylinder 4 Contribution/Balance Fault
Glow Plug/Heater Circuit 'A' Malfunction
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
Timing Reference High Resolution Signal A Too Many Pulses
Turbocharger Boost Sensor A Circuit Low
Fuel Composition Sensor Circuit Malfunction
Cold Start Injector 1 Malfunction
Fuel Temperature Sensor B Circuit Range/Performance

What To Check After Fixing 14902 Code

Inspect all the connections pressure control solenoid 2 (n216), short to b+
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

14902 Fault Code For Volkswagen Vehicles

The fault code 14902 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 14902 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24