VW Code 14867
14867 Description And Summary : |
|---|
Diameter in engine exhaust gas temperature sensor, bank 2 sensor 4, circuit high It could be due to limited air getting through your air intake relays for small amount of heat (j359), disconnected or short to ground or change actuator supply voltage "b", circuit /open is the final reason of the code. |
14867 Possible Causes:
14867 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 14867 Code
- Inspect all the connections intake manifold runner bank 1 control, basic setting aborted mechanical limit open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns