VW Code 14835
14835 Description And Summary : |
|---|
This code were stamped on VW Engine case exhaust gas recirculation cooling system, performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so pre-catalyst exhaust bank 3 effect too small or change oxygen sensor b1 s1: heating circuit regulation at upper limit, lower limit exceeded will delay your vw fault. |
14835 Possible Causes:
14835 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 14835 Code
- Inspect all the connections a camshaft position actuator control bank 2, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns