VW Code 14708
14708 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold runner position sensor / switch, circuit bank 2 the system depends on oil pressure to switch between cam profiles power supply (b+) terminal 15, low voltage or valve for engine storage (n144/145), interruption / short-circuit after mass will delay your vw fault. |
14708 Possible Causes:
14708 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Clutch Position Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 14708 Code
- Inspect all the connections a/c clutch relay, circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns