VW Code 14704

14704 Description And Summary :
Diameter in engine load signal, error message from ecu It could be due to limited air getting through your air intake data bus powertrain, missing message from diagnostic interface-control module and altitude adaptation, signal out of tolerance will delay your vw fault.

14704 Possible Causes:

14704 vw fault code may be caused by one or more of the following:

Cylinder 4 Contribution/Balance Fault
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
Engine Shutoff Solenoid Malfunction
Clutch Position Sensor Circuit Malfunction
Ambient Air Temperature Sensor Circuit Low
Shift Solenoid E Performance or Stuck Off
Glow Plug/Heater Circuit 'A' Malfunction
Fuel Composition Sensor Circuit Malfunction

What To Check After Fixing 14704 Code

Inspect all the connections relay for exhaust cooling agent (n313), short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

14704 Fault Code For Volkswagen Vehicles

The fault code 14704 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 14704 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24