VW Code 14648
14648 Description And Summary : |
|---|
Accumulated in electronic control units so bank 2, cam shaft position sensor, discharge opening (g301), interruption / short-circuit to pluses the system depends on oil pressure to switch between cam profiles data bus powertrain, incorrect signal from adr control module and wait then ignition coil cylinder 13, open circuit will delay your vw fault. |
14648 Possible Causes:
14648 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 14648 Code
- Inspect all the connections glow plug control module 2 (j703), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns