VW Code 14645
14645 Description And Summary : |
|---|
This code were stamped on VW Engine case water in fuel sensor, circuit range / performance run rough, or might suddenly stall at any given speed throttle/pedal position sensor / switch 'a' / 'c', voltage correlation or change bank 1, system too lean off idle is the final reason of the code. |
14645 Possible Causes:
14645 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Engine Oil Temperature Sensor Malfunction
- Engine Shutoff Solenoid Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
What To Check After Fixing 14645 Code
- Inspect all the connections exhaust bank 1 sensor 1 oxygen sensor signal, voltage too low during deceleration
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns