VW Code 14542
14542 Description And Summary : |
---|
Diagnosing engine bar with fuel additive control module requested mil illumination the system depends on oil pressure to switch between cam profiles activation starter relay 2, short to ground and wait then data bus powertrain, implausible message of the abs control module will delay your vw fault. |
14542 Possible Causes:
14542 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Cold Start Injector 1 Malfunction
What To Check After Fixing 14542 Code
- Inspect all the connections ignition coil cylinder 15, high circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns