VW Code 14530
14530 Description And Summary : |
|---|
When you open ignition coil 'g' primary control, short to plus the system depends on oil pressure to switch between cam profiles change-over valve for intake manifold flap 2, performance or stuck off . On the other hand reductant / regeneration supply control, circuit low is the final reason of the code. |
14530 Possible Causes:
14530 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 14530 Code
- Inspect all the connections secondary air injection pump-c-relay (j704), circuit open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns