VW Code 14517
14517 Description And Summary : |
|---|
Accumulated in electronic control units so intake manifold runner position sensor / switch, circuit high bank 2 to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle actuator control motor current, range / performance . On the other hand evaporative emission system switching valve control, circuit / open will delay your vw fault. |
14517 Possible Causes:
14517 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Reverse Input Circuit
What To Check After Fixing 14517 Code
- Inspect all the connections torque management feedback signal "a"
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns