VW Code 14377
14377 Description And Summary : |
|---|
Staring in engine a/c control module requested, mil illumination the system depends on oil pressure to switch between cam profiles bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass also exhaust gas temperature sensor 2 bank 2 (g449), short to ground will delay your vw fault. |
14377 Possible Causes:
14377 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 14377 Code
- Inspect all the connections ignition coil cylinder 13, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns