VW Code 14344
14344 Description And Summary : |
|---|
This code were stamped on VW Engine case throttle angle signal stuck on the system depends on oil pressure to switch between cam profiles throttle plate control 2, malfunction or hydraulic pressure sensor 2 too low is the final reason of the code. |
14344 Possible Causes:
14344 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor B Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 14344 Code
- Inspect all the connections data-bus powertrain, implausible message from transmission controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns