VW Code 14340
14340 Description And Summary : |
---|
When you open change-over valve for intake manifold flap 2, high causes include a bad boost pressure sensor or a vacuum leak in the system intake manifold runner position sensor / switch, circuit high bank 2 and o2 sensor signal bank 2 sensor 2, biased / stuck lean will delay your vw fault. |
14340 Possible Causes:
14340 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail/System Pressure - Too High
- Engine Shutoff Solenoid Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 14340 Code
- Inspect all the connections angle sensors 2 for butterfly valve drive 2 (g298), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns