VW Code 14276
14276 Description And Summary : |
|---|
When you open injector control pressure regulator, circuit low the system depends on oil pressure to switch between cam profiles throttle/pedal position sensor / switch 'f', circuit range / performance . On the other hand exhaust bank 3 sensor 1 oxygen sensor signal, implausibly rich will delay your vw fault. |
14276 Possible Causes:
14276 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 10 Contribution/balance Fault
- Cold Start Injector 1 Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 14276 Code
- Inspect all the connections data bus powertrain, missing message from a/c controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns