VW Code 14268
14268 Description And Summary : |
|---|
This code were stamped on VW Engine case control module defective the system depends on oil pressure to switch between cam profiles reductant injection valve bank 2 unit 1, circuit / open you can see the injector control pressure, too high is the final reason of the code. |
14268 Possible Causes:
14268 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
What To Check After Fixing 14268 Code
- Inspect all the connections combustion detection during deceleration
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns