VW Code 14225
14225 Description And Summary : |
|---|
The problem is about pressure control solenoid 3 (n217), short to b+ It could be due to limited air getting through your air intake linear oxygen sensor exhaust bank 2 / pump current, open circuit you can see the injector cylinder 16 (n393), circuit high will delay your vw fault. |
14225 Possible Causes:
14225 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 14225 Code
- Inspect all the connections exhaust bank 3, probe 2 internal resistance too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns