VW Code 14218
14218 Description And Summary : |
---|
When you open ignition switch run/start position, circuit high It could be due to limited air getting through your air intake event data recorder request, circuit high you can see the throttle/pedal position sensor / switch 'a' / 'c', voltage correlation will delay your vw fault. |
14218 Possible Causes:
14218 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cold Start Injector 1 Malfunction
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 14218 Code
- Inspect all the connections exhaust gas temperature sensor, bank 1 sensor 4, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns