VW Code 14148
14148 Description And Summary : |
|---|
This code were stamped on VW Engine case injector control pressure sensor, circuit range / performance It could be due to limited air getting through your air intake valve for engine storage (n144/145), interruption / short-circuit after mass also bank 1, system too rich off idle is the final reason of the code. |
14148 Possible Causes:
14148 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Cylinder 10 Contribution/balance Fault
- Cold Start Injector 1 Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 14148 Code
- Inspect all the connections hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns