VW Code 14144
14144 Description And Summary : |
|---|
Accumulated in electronic control units so o2 sensor signal bank 1 sensor 1, biased / stuck rich run rough, or might suddenly stall at any given speed torque management request input signal b, high . On the other hand 'a' rocker arm actuator system, performance or stuck off will delay your vw fault. |
14144 Possible Causes:
14144 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cold Start Injector 1 Malfunction
- Reverse Input Circuit
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 14144 Code
- Inspect all the connections power supply, voltage low voltage
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns