VW Code 14130
14130 Description And Summary : |
|---|
When you open b camshaft position actuator control bank 1, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so supply voltage for fuel injector group b, open circuit or change valve for intake manifold flap (n239), short to ground will delay your vw fault. |
14130 Possible Causes:
14130 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 14130 Code
- Inspect all the connections exhaust bank 4, sensor 2 heater circuit, short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns