VW Code 14128
14128 Description And Summary : |
|---|
Diameter in engine torque management request input signal a to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve for pump - jet: cylinder 12 (n308), electrical malfunction . On the other hand fuel injection valve 2 (n367), short to b+ will delay your vw fault. |
14128 Possible Causes:
14128 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor B Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Fuel Rail Pressure Sensor Circuit Malfunction
- Reverse Input Circuit
What To Check After Fixing 14128 Code
- Inspect all the connections torque management feedback signal "b", range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns