VW Code 14095
14095 Description And Summary : |
|---|
Diameter in engine injector cylinder 14 (n392), open circuit run rough, or might suddenly stall at any given speed intake manifold tuning (imt) valve position sensor / switch bank 1, circuit range / performance also intake manifold flap position sensor (bank 1): implausible signal will delay your vw fault. |
14095 Possible Causes:
14095 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Malfunction
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 14095 Code
- Inspect all the connections tiptronic switch down, circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns