VW Code 14068
14068 Description And Summary : |
|---|
Accumulated in electronic control units so angle sensors 1 for butterfly valve drive 2 (g297), signal too largely the system depends on oil pressure to switch between cam profiles exhaust gas temperature control circuit bank 4, out of range or change o2 sensor reference voltage bank 2 sensor 1, performance will delay your vw fault. |
14068 Possible Causes:
14068 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Cylinder 10 Contribution/balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 14068 Code
- Inspect all the connections data bus powertrain, missing messages from steering wheel electronics (j527)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns