VW Code 14063
14063 Description And Summary : |
|---|
This code were stamped on VW Engine case cylinder 9 above knock threshold to change the oil filter and use the recommended engine oil to avoid any problems in the future so generator shut-off, open or short to ground or throttle position output, circuit high is the final reason of the code. |
14063 Possible Causes:
14063 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 14063 Code
- Inspect all the connections ignition switch accessory position, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns