VW Code 14060
14060 Description And Summary : |
|---|
When you open turbocharger 2 control module (j725), high temperature to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'f' secondary circuit, malfunction or change ignition coil 'j' primary control, short to plus will delay your vw fault. |
14060 Possible Causes:
14060 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 14060 Code
- Inspect all the connections 'a' rocker arm actuator system, performance or stuck off
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns