VW Code 14031
14031 Description And Summary : |
|---|
Diameter in engine ignition switch run position, circuit high run rough, or might suddenly stall at any given speed vehicle speed signal, circuit open and wait then event data recorder request, circuit high is the final reason of the code. |
14031 Possible Causes:
14031 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Fuel Temperature Sensor B Circuit Range/Performance
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 14031 Code
- Inspect all the connections ignition coil 'j' primary control, short to plus
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns