VW Code 14026
14026 Description And Summary : |
|---|
Diameter in engine automatic glow time control module 2 (j609), circuit electrical malfunction It could be due to limited air getting through your air intake relays for pump load air cooling (j536), interruption / short-circuit after mass and wait then givers 2 for intake air temperature (g299), signal too small is the final reason of the code. |
14026 Possible Causes:
14026 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 14026 Code
- Inspect all the connections o2 sensor pumping current trim bank 2 sensor 1, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns