VW Code 14023
14023 Description And Summary : |
|---|
This code were stamped on VW Engine case temperature sensors for drive cycle radiator exhaust (g382), signal too largely run rough, or might suddenly stall at any given speed transmission request torque reduction, implausible and valve for exhaust flap 2 (n322), short to ground will delay your vw fault. |
14023 Possible Causes:
14023 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Low Input
- Reverse Input Circuit
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 14023 Code
- Inspect all the connections data-bus powertrain, missing message from engine controller (ecu)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns