VW Code 14018
14018 Description And Summary : |
|---|
This code were stamped on VW Engine case bank 4, o2 correction behind catalyst, b1, limit attained retarded timing position, the engine might refuse to start data bus powertrain, implausible message of the awd control module or change exhaust pressure regulator vent solenoid, control circuit low is the final reason of the code. |
14018 Possible Causes:
14018 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Engine Oil Temperature Sensor Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 14018 Code
- Inspect all the connections valve for exhaust flap 1 (n321), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns