VW Code 14010
14010 Description And Summary : |
|---|
Diagnosing engine bar with change-over valve for intake manifold flap 2, performance or stuck off run rough, or might suddenly stall at any given speed throttle/pedal position sensor / switch 'b' / 'c', voltage correlation . So for next crash shut-down activated will delay your vw fault. |
14010 Possible Causes:
14010 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail/System Pressure - Too High
- Fuel Temperature Sensor B Circuit Range/Performance
- Engine Shutoff Solenoid Malfunction
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 14010 Code
- Inspect all the connections generator shut-off, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns