VW Code 13967
13967 Description And Summary : |
|---|
This code were stamped on VW Engine case valve for pump - jet, cylinder 5 (n244), electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so temperature sensors for drive cycle radiator exhaust (g382), signal too largely and wait then ng high pressure valve (n372), short to ground is the final reason of the code. |
13967 Possible Causes:
13967 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 13967 Code
- Inspect all the connections butterfly valve control unit 2 (j544), lower notice one does not reach
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns