VW Code 13929
13929 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust bank 3, probe 1 heating circuit short-circuit after pluses run rough, or might suddenly stall at any given speed intake manifold runner control, circuit high bank 2 . On the other hand internal control module: eeprom error will delay your vw fault. |
13929 Possible Causes:
13929 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 13929 Code
- Inspect all the connections pressure control valve 1 (n215), open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns