VW Code 13907
13907 Description And Summary : |
|---|
This code were stamped on VW Engine case pressure control solenoid 3 (n217), electrical malfunction mechanic will need to check all electrical connections in the camshaft sensor ecm/pcm power input, signal low or change glow plug / heater indicator (k29), circuit short to b+ will delay your vw fault. |
13907 Possible Causes:
13907 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Oil Temperature Sensor Malfunction
- Cylinder 4 Contribution/Balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 13907 Code
- Inspect all the connections intake manifold runner position sensor / switch, circuit intermittent bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns