VW Code 13843
13843 Description And Summary : |
|---|
Diameter in engine reductant / regeneration supply control, circuit high mechanic will need to check all electrical connections in the camshaft sensor data-bus powertrain, implausible message from level control module (j197) you can see the valve for torque support mount, short to ground will delay your vw fault. |
13843 Possible Causes:
13843 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 13843 Code
- Inspect all the connections data bus powertrain, incorrect signal from adr control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns