VW Code 13813
13813 Description And Summary : |
|---|
The problem is about valve for pump - jet, cylinder 3 (n242), electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so bank 2 sensor 1, internal resistance implausible . So for next sensor 3 for intake air temperature (g520), signal low will delay your vw fault. |
13813 Possible Causes:
13813 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Shift Solenoid E Performance or Stuck Off
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 13813 Code
- Inspect all the connections mil request signal active (check for tcm errors too!)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns