VW Code 13807
13807 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault cam shaft position sensor (g40), no signal the system depends on oil pressure to switch between cam profiles ignition coil 'l' primary control, circuit low and wait then accelerator position sensor 2 (g185), signal too low will delay your vw fault. |
13807 Possible Causes:
13807 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 13807 Code
- Inspect all the connections valve for engine storage (n144/145), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns