VW Code 13758
13758 Description And Summary : |
---|
When you open air cleaner inlet control, circuit high the system depends on oil pressure to switch between cam profiles glow plug/heater relay 2 circuit, open or short to ground and wait then powertrain databus, implausible engine temperature message from inst. will delay your vw fault. |
13758 Possible Causes:
13758 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 13758 Code
- Inspect all the connections tiptronic switch down (f189), open circuit / signal to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns