VW Code 13718
13718 Description And Summary : |
---|
Accumulated in electronic control units so exhaust gas recirculation cooling valve control, circuit / open retarded timing position, the engine might refuse to start glow plug / heater relay, circuit short to b+ . On the other hand data bus powertrain, missing message from diagnostic interface-control module is the final reason of the code. |
13718 Possible Causes:
13718 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Composition Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 13718 Code
- Inspect all the connections engine torque reduction, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns