VW Code 13686
13686 Description And Summary : |
|---|
This code were stamped on VW Engine case throttle/pedal position sensor 'a', maximum stop performance the system depends on oil pressure to switch between cam profiles butterfly valve control unit 2 (j544), of mechanical errors . So for next intake manifold flap; bank 1, stuck open is the final reason of the code. |
13686 Possible Causes:
13686 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Fuel Rail/System Pressure - Too High
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 13686 Code
- Inspect all the connections exhaust gas temperature sensor bank 1 sensor 1, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns