VW Code 13682
13682 Description And Summary : |
|---|
This something to do with the intake camshaft timing hydraulic pressure sensor 1, range / performance the system depends on oil pressure to switch between cam profiles hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation and wait then fuel shutoff valve "b" control, circuit high will delay your vw fault. |
13682 Possible Causes:
13682 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Reverse Input Circuit
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 13682 Code
- Inspect all the connections please check dtc memory of steering wheel electronics
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns