VW Code 13677
13677 Description And Summary : |
|---|
Diameter in engine pressure control solenoid 4 (n218), electrical malfunction run rough, or might suddenly stall at any given speed power supply (b+) terminal 15, voltage too high you can see the tiptronic switch up, circuit short to ground will delay your vw fault. |
13677 Possible Causes:
13677 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Ambient Air Temperature Sensor Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 13677 Code
- Inspect all the connections air cleaner inlet control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns