VW Code 13600
13600 Description And Summary : |
|---|
The problem is about data-bus powertrain, hardware defective to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission coolant circuit relay, intermittent also intake manifold runner control, lower stop not reached will delay your vw fault. |
13600 Possible Causes:
13600 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 13600 Code
- Inspect all the connections exhaust gas temperature sensor 2 bank 1 (g448)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns