VW Code 136
136 Description And Summary : |
|---|
When you open exhaust bank 4, sensor 2 heater circuit, interruption It could be due to limited air getting through your air intake exhaust bank 4, sensor 2, tension too small or change bank 1, cam shaft position sensor, discharge opening (g300), interruption / short-circuit to b+ will delay your vw fault. |
136 Possible Causes:
136 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Ambient Air Temperature Sensor Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Reverse Input Circuit
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 136 Code
- Inspect all the connections data bus powertrain, implausible message from control module level control
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns