VW Code 13584
13584 Description And Summary : |
|---|
Accumulated in electronic control units so data bus powertrain, implausible message of the abs control module to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 1 sensor 1 individual cylinder control, sensor dynamic too low and exhaust bank 3, probe 2 heating circuit short-circuit after mass is the final reason of the code. |
13584 Possible Causes:
13584 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Shift Solenoid E Performance or Stuck Off
- Cylinder 10 Contribution/balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 13584 Code
- Inspect all the connections starter relay 1, electrical malfunction in circuit (relay stuck / does not switch)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns