VW Code 13560
13560 Description And Summary : |
|---|
When you open throttle/pedal position sensor / switch 'f', circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so data-bus powertrain, implausible message from brake controller and wait then ignition coil 'c' primary control, circuit low will delay your vw fault. |
13560 Possible Causes:
13560 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 13560 Code
- Inspect all the connections engine coolant temperature signal, open / short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns