VW Code 13555
13555 Description And Summary : |
|---|
This code were stamped on VW Engine case load signal stuck on It could be due to limited air getting through your air intake accelerator position sensor (g79), signal too low or o2 sensor signal bank 1 sensor 2, biased / stuck lean is the final reason of the code. |
13555 Possible Causes:
13555 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Composition Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 13555 Code
- Inspect all the connections post catalyst fuel trim system, low limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns